A lack of timeout in I2C could cause
the worker could get stuck in a loop
if the communication has been broken somehow.
The Harmony is unresponsive in this case.
The only solution is just to perform a hardware
reset using Frontlight and Back buttons simultaneously.
There are also additional 5 attempts to read and write
transactions if the bus error occurs in the Fuel Gauge driver.
It should be sufficient but if it would still persists
the system just will read 0% SOC and shutdown system.
It appears in the past a major edit was made but had used a regex to
change some text which resulted in an errant space between the
enumuneration/struct/class name and the scope resolution operator.
These errant spaces have been removed.
