* Fix of the issue that source clock for PWM
module was improperly assumed to be derived
from AHB_CLK, while in reality it is
derived from IPG_CLK, what resulted in
module generating signal with 4 times
lower frequency than the configured
one.
* Cleanups.
* Added extended logging to Pure's charger driver.
* Removed redundant handling of INOKB pin
interrupt - charger is configured to provide
the same interrupt via INTB pin.
* Minor code cleanup.
The system closes only if the SoC is 0%, but
it doesn't react if the voltage has low level.
The new implementation invokes the close
procedure if the voltage is less than 3.4V.
This solution should avoid possiblity to
hang the MCU.
In rare cases when corresponding Press and Release key events were not
generated the logic prevented other keys from being handled. Handling of
other keys is no longer blocked.
In addition to the above Release event is artificially generated. This
ensures that key presses are not ignored if there were no real Release
event. Typically this may occur when keys are pressed fast one after
another. A side effect is that when a key was pressed while other one
was already pressed then both of them are handled by the UI which
prevents e.g. letters from being ignored while writing.
Improve structure of the module sys. Problems within this module
prevents from linking others.
Signed-off-by: Marcin Smoczyński <smoczynski.marcin@gmail.com>
Split module-utils into smaller components for better dependency
management. Fix many dependencies throughout the project.
Signed-off-by: Marcin Smoczyński <smoczynski.marcin@gmail.com>
Remove system dependency from charger driver implementation. Remove
circular, lambda driven dependency between charger and brownout
detector. Remove event manager dependency in driver as well.
Encapsulate some of charger logic in introduced battery controller.
Extract path configuration to the separate target to decouple charger
from vfs middleware.
Signed-off-by: Marcin Smoczyński <smoczynski.marcin@gmail.com>
