diff --git a/src/mesh/LR11x0Interface.cpp b/src/mesh/LR11x0Interface.cpp
index c475c9e7de..dcddac3f9d 100644
--- a/src/mesh/LR11x0Interface.cpp
+++ b/src/mesh/LR11x0Interface.cpp
@@ -38,16 +38,6 @@ static_assert(sizeof(lr11x0_switch_dio_nums) / sizeof(lr11x0_switch_dio_nums[0])
                   sizeof(lr11x0_switch_dio_consts) / sizeof(lr11x0_switch_dio_consts[0]),
               "LR11x0 switch DIO numbers and constants must describe the same slots");
 
-// MESHTASTIC_PRESTAGE_VIA_PHY routes the prestage payload write through RadioLib's chip-neutral
-// PhysicalLayer::writeTxBuffer() (jgromes/RadioLib#1890) instead of the chip-specific call this branch
-// has been using. The staged bytes are the same; what differs is the command that carries them, and on
-// SX126x writeTxBuffer() also sends a buffer-base command of its own first.
-#ifdef MESHTASTIC_PRESTAGE_VIA_PHY
-#define MESHTASTIC_STAGE_TX_PAYLOAD(n) lora.writeTxBuffer((uint8_t *)&radioBuffer, (n))
-#else
-#define MESHTASTIC_STAGE_TX_PAYLOAD(n) lora.writeBuffer8((uint8_t *)&radioBuffer, (n))
-#endif
-
 // This part has MODE_TX_HP/MODE_GNSS/MODE_WIFI and no MODE_RX_HF.
 static const int32_t lr11x0_rfswitch_mode_map[RFSW_MODE_COUNT] = {
     LR11x0::MODE_STBY,  LR11x0::MODE_RX,       LR11x0::MODE_TX,   LR11x0::MODE_TX_HP,
@@ -64,6 +54,16 @@ static const Module::RfSwitchMode_t rfswitch_table[] = {
 };
 #endif
 
+// MESHTASTIC_PRESTAGE_VIA_PHY routes the prestage payload write through RadioLib's chip-neutral
+// PhysicalLayer::writeTxBuffer() (jgromes/RadioLib#1890) instead of the chip-specific call this branch
+// has been using. The staged bytes are the same; what differs is the command that carries them, and on
+// SX126x writeTxBuffer() also sends a buffer-base command of its own first.
+#ifdef MESHTASTIC_PRESTAGE_VIA_PHY
+#define MESHTASTIC_STAGE_TX_PAYLOAD(n) lora.writeTxBuffer((uint8_t *)&radioBuffer, (n))
+#else
+#define MESHTASTIC_STAGE_TX_PAYLOAD(n) lora.writeBuffer8((uint8_t *)&radioBuffer, (n))
+#endif
+
 // Particular boards might define a different max power based on what their hardware can do, default to max power output if not
 // specified (may be dangerous if using external PA and LR11x0 power config forgotten)
 #if ARCH_PORTDUINO