mirror of
https://github.com/meshtastic/firmware.git
synced 2026-09-16 16:41:24 -04:00
SeanandTom
42d32fcea6
limitPower() converts the member `power` in place (regulatory clamp, then the TX_GAIN_LORA/FEM subtraction) and relied on applyModemConfig() having just re-seeded it. Since #10025 every driver calls it from both reinitChip() and programModemParams(), and the recovery paths added in #11676/#11678 run the two back-to-back, so each recovery re-converts an already-converted value. On a RAK13302 (22-entry gain table) one recovery walks a 30 dBm request 30 -> 22 -> 13 dBm and a second one down toward the -9 dBm floor, while config.lora.tx_power still reads 30. Seed `power` from config.lora.tx_power at the top of limitPower(); applyModemConfig() always writes the resolved value back there, so a single call is unchanged. Co-authored-by: Tom <116762865+NomDeTom@users.noreply.github.com>
Meshtastic Firmware
Overview
This repository contains the official device firmware for Meshtastic, an open-source LoRa mesh networking project designed for long-range, low-power communication without relying on internet or cellular infrastructure. The firmware supports various hardware platforms, including ESP32, nRF52, RP2040/RP2350, and Linux-based devices.
Meshtastic enables text messaging, location sharing, and telemetry over a decentralized mesh network, making it ideal for outdoor adventures, emergency preparedness, and remote operations.
Get Started
- 🔧 Building Instructions - Learn how to compile the firmware from source.
- ⚡ Flashing Instructions - Install or update the firmware on your device.
Join our community and help improve Meshtastic! 🚀
Stats
