mirror of
https://github.com/meshtastic/firmware.git
synced 2026-10-09 06:31:35 -04:00
dee945cd6a
* CH341: fewer waits on the USB bus per radio command Every RadioLib command to a radio behind a CH341 waits on the USB bus about five times: the BUSY read before it, CS low, the command, CS high, and the BUSY read after, with a 1 us settle between the last two that usleep() turns into ~50 us of timer slack. - A BUSY read that follows the read that found BUSY low after a command is answered from it, once, within 1 ms and only if nothing else has been sent to the adapter in between: RadioLib's wait before a command then costs nothing after the wait that ended the last one. - Delays under 100 us spin on the steady clock instead of sleeping. - With a libch341 that has pinedio_transceive_select(), and where Lora.CS is D0, the CS levels travel with the SPI transfer and RadioLib's separate CS writes are dropped. Against an older libch341 this part compiles out. The HAL learns the radio's CS and BUSY pins from initLoRa(), since USBHal.h is included by PortduinoGlue.h ahead of portduino_config. Measured on an SX1262 over a CH341 (SHORT_TURBO, 6 v 6 runs of 300 s): the three-command CAD setup fell 1.01 -> 0.62 ms, CAD arm to air 6.60 -> 5.23 ms, and total packet loss 1.51 -> 1.13% (p=0.048), with collisions 4.83 -> 0.67 per run (p=0.002). Co-Authored-By: Jonathan Bennett <jbennett@incomsystems.biz> Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01REkPVFh6kvG4AZJ5A8AtM9 * Bump libch341-spi-userspace to 027cde5 for pinedio_transceive_select() Picks up libch341#6 (1 ms interrupt poll, poll thread woken on detach) and #7 (pinedio_transceive_select()), so the packed-CS path in USBHal.h builds in rather than compiling out. Co-Authored-By: Jonathan Bennett <jbennett@incomsystems.biz> Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01REkPVFh6kvG4AZJ5A8AtM9 --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com> Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
Meshtastic Firmware
Overview
This repository contains the official device firmware for Meshtastic, an open-source LoRa mesh networking project designed for long-range, low-power communication without relying on internet or cellular infrastructure. The firmware supports various hardware platforms, including ESP32, nRF52, RP2040/RP2350, and Linux-based devices.
Meshtastic enables text messaging, location sharing, and telemetry over a decentralized mesh network, making it ideal for outdoor adventures, emergency preparedness, and remote operations.
Get Started
- 🔧 Building Instructions - Learn how to compile the firmware from source.
- ⚡ Flashing Instructions - Install or update the firmware on your device.
Join our community and help improve Meshtastic! 🚀
Stats
